General UV DTF Wraps

UV DTF TRaNSFeRS

TRANSFERS TO ANY HARD SURFACE!

UV DTF transfers do not require weeding and apply to any hard surface in seconds! They are fully waterproof and when cared for properly, will last the life of the object applied to!

APPLICATION INSTRUCTIONS:

1. PREPARE SURFACE

   Clean the surface where the transfer will be applied, ensuring that the surface is free of dirt, debris and lint and is dry

2. PREPARE TRANSFER

   Using your craft squeegee, carefully rub over the transfer while it is still on the white backing. This helps to ensure there are no bubbles between the image and the transfer sheet

3. REMOVE BACK PAPER LINER

   Slowly remove the clear transfer film, which holds the image, from the back paper liner

4. ALIGN TRANSFER & PRESS

   After removing the back paper liner, carefully apply the transfer to the surface using your craft squeegee to go over the transfer, removing any air bubbles as you go. Ensure you've firmly pressed the transfer to the surface

5. REMOVE CLEAR TRANSFER FILM

   Carefully peel up the top layer of film, working your way from one side to the other. Work slowly and carefully while watching that the design is not lifting with the transfer film. If you find that it is lifting, squeegee the remaining film again before peeling the remaining transfer film

Enjoy!