Kids Water Tumbler

Kids 12oz. Water Tumbler skinny straight for Sublimation (No template for this product)

PLEASE NOTE: equipment varies and so may your required settings. Please test your own equipment using these baseline recommendations. The settings below may need adjustments for best results. Settings will vary depending on the heat press brand and model ink and paper and atmospheric conditions.

Apply sublimation transfer on the surface of the tumbler using heat tape. Make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler. Pulling the tape/transfer as tight as possible with no air pockets. If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that there is no metal showing on the sides.
Apply shrink wrap using a heat gun to shrink it tight to the tumbler.
Bake in a convection oven at approximately 385-400 degrees F for 5-6 minutes, turning halfway. If your tumbler is touching a metal surface during baking, the shrink wrap will be more likely to melt
Remove from oven and immediately remove shrink wrap and transfer. TUMBLER WILL BE HOT!!

No sealant is necessary on sublimation tumblers.

Hand washing is recommended as the high heat in many dishwashers may reactivate the heat and cause it to bleed.